REATTACHING THE REFRIGERATOR DOORS
4. Connect the dispenser door tube ( 5 ) and then | 4 | 3 |
insert a clip on the coupler with pulling tube. |
| |
|
|
Connect the connector ( 4 ) on the left side door and two connectors ( 3 ) at each side of the top cap.
The clip is enveloped inside of the top cap.
5
The dispenser door tube ( 5 ) must be fully inserted to the marked CAUTION line to prevent water leakage from the dispenser.
3
dispenser door tube
coupler
PU ESTTING01
5.Position the top table ( 2 ) in place. Insert and tighten the 3 screws into the top table with a philips screw driver(+). With the doors open, reinsert the cap top table ( 1 ) and close the doors.
When reattaching the top table, make sure that the wires are not pressed or damaged by the hinge cover.
After assembling, close the doors and check to see whether the doors have gaps between gaskets or are tilted. If you see a gap or tilt please refer to “Adjusting the doors” on page 15.
2
1
Setting up _13
