HOW TO USE

MECHANICAL TEMPERATURE ADJUSTMENT

 

The temperature is adjusted by the slide under the

 

control of temperature controller. The signs, strong ,

 

mediate and weak , on the knob receptively indicate

 

 

the inside temperature condition. Under the same

 

circumstance, stronger the knob reflects, lower the

Season switch

inside temperature is. Close means stopping working.

 

Temperature adjustment

 

 

 

In normal use, adjust the slide at the mediate

and

 

change it to the location between weak and

mediate

 

if any hot weather. If the room temperature is below

 

15 , then open the season switch and change the

 

slide to the location between mediate

and strong .

 

If the room temperature is below 10

, it's a must to

 

locate the slide at the Winter area.

 

 

FRUIT AND VEGETABLE COMPARTMENT

DISASSEMBLING PARTS

Refrigerator shelf

Draw out it till the block, lift the shelf rear and pull it out.

(position the shelf as per the container's height)

Fruit and vegetable tray and cover

Pull out the fruit and vegetable tray.

Drive up the cover head and put it out.

Freezer tray

Draw out it till the block, lift the shelf rear and pull it out.

Egg guard and bottle guard

Lift them up to dismantle it.

Cover

Moisture

control slide

Fruit and

vegetable

tray

Partition

You may adjust the moisture of the fruit and vegetable compartment by the moisture control slide. The slide towards the two sides may increase the moisture, vice versa.

The partition of the fruit and vegetable tray separates the fruit and vegetable compartment into two parts. You are allowed to adjust it according to the fruit and vegetable types and quantities to meet a satisfactory need of storage space.

The fruit and vegetable compartment is able to preserve the water content and freshness of the fruits and vegetables as it is sealed to prevent cold air touching the fruits and vegetables. It is appropriate to the storage of vegetables and fruits.

The wire bar of the bottle guard may vary as per requirement.

REPLACE OF BUILT-IN LIGHT

Pull out the plug

Turn off the screw in the lampshade back press the center by fingers and push back to take out the lampshade.

Turn off the bulb counterclockwise.

Screw on the bulb clockwise.

Hang on the hook under the cover and turn upward to push into the upper hook.

Caution:

Tropical fruits, such as banana and pineapple are not recommended.

Lamp parameter: 220V/240V, 15W

8

5