HOW TO USE
MECHANICAL TEMPERATURE ADJUSTMENT
| The temperature is adjusted by the slide under the | ||
| control of temperature controller. The signs, strong , | ||
| mediate and weak , on the knob receptively indicate | ||
| |||
| the inside temperature condition. Under the same | ||
| circumstance, stronger the knob reflects, lower the | ||
Season switch | inside temperature is. Close means stopping working. | ||
| Temperature adjustment |
|
|
| In normal use, adjust the slide at the mediate | and | |
| change it to the location between weak and | mediate | |
| if any hot weather. If the room temperature is below | ||
| 15 , then open the season switch and change the | ||
| slide to the location between mediate | and strong . | |
| If the room temperature is below 10 | , it's a must to | |
| locate the slide at the Winter area. |
|
|
FRUIT AND VEGETABLE COMPARTMENT
DISASSEMBLING PARTS
Refrigerator shelf
Draw out it till the block, lift the shelf rear and pull it out.
(position the shelf as per the container's height)
Fruit and vegetable tray and cover
Pull out the fruit and vegetable tray.
Drive up the cover head and put it out.
Freezer tray
Draw out it till the block, lift the shelf rear and pull it out.
Egg guard and bottle guard
Lift them up to dismantle it.
Cover
Moisture
control slide
Fruit and
vegetable
tray
Partition
You may adjust the moisture of the fruit and vegetable compartment by the moisture control slide. The slide towards the two sides may increase the moisture, vice versa.
The partition of the fruit and vegetable tray separates the fruit and vegetable compartment into two parts. You are allowed to adjust it according to the fruit and vegetable types and quantities to meet a satisfactory need of storage space.
The fruit and vegetable compartment is able to preserve the water content and freshness of the fruits and vegetables as it is sealed to prevent cold air touching the fruits and vegetables. It is appropriate to the storage of vegetables and fruits.
The wire bar of the bottle guard may vary as per requirement.
REPLACE OF BUILT-IN LIGHT
Pull out the plug
Turn off the screw in the lampshade back
press the center by fingers and push back to take out the lampshade.
Turn off the bulb counterclockwise.
Screw on the bulb clockwise.
Hang on the hook under the cover and turn upward to push into the upper hook.
Caution:
Tropical fruits, such as banana and pineapple are not recommended.
Lamp parameter: 220V/240V, 15W
8 | 5 |