Samsung RS23FESW Installing Of The Water Dispenser Line, Connecting to water supply line, Case

INSTALLING OF THE WATER DISPENSER LINE

For Interior Model (Case 1)

Connecting to water supply line

- Shut off the main water supply line and turn the Ice maker to the off position.

- Locate the nearest cold drinking water line.

- Follow the instructions in the ice maker installation kit.

1.Cold Water line

2.Pipe Clamp. 3.Copper (or Plastic) line 4.Compression Nut 5.Compression Sleeve 6.Shut Off Valve 7.Packing Nut.

Connect the water line to the refrigerator

-Slip the compression nut and plastic ferrule through the plastic tube.

-After inserting the sleeve, tighten the compres-sion nut onto 1/4” compression fitting(union).

Do not overtighten the compression nut.

NOTE

-Slip the compression ferrule and nut on copper(or plastic) tubing as shown.

Tighten the comperssion nut onto the com-pression fitting(union).

- Turn water on and check for any leakege.

Compression

Nut

Ferrule

Sleeve

Compression fitting

Ferrule

Compressi on Nut

Waterline must be connected to drinkable water only

NOTE

(Case 2)

Check the water supply line

Connect the water pipe with coupler and tap.

-Close the main water tap.

-Connect coupler “A” to the tap.

-Every join should be protected with sealing tape.

WARRANTY INFORMATION

This water line installation is not covered by the refriger-ator or ice maker manufacturer's warranty.

Follow these instructions carefully to minimise the risk of expensive water damage.

Note:

If the coupler does not fit on the current tap, go

the nearest authorised service dealer and purchase

the right couplers fittings.

CAUTION

The water line must be connect-ed

to the cold water pipe.

If it is connected to the hot waterpipe, it may cause the purifier to malfunction.

COUPLER “A”

TAP

30