Removing residual matter inside the water supply line after installing filter
1.Turn ON the main water supply.
2.Press the Water button and push the dispenser pad.
Refer to ‘Checking the control panel’ in the manual (page 22) | Ice | Water |
3. Flush 3 gallons of water through the filter befor use. |
|
|
(Flush approximately 6 minutes.) |
|
|
This will clean the water supply system and remove air from the lines. |
|
|
4. Additional flushing may be required in some households.
5.Open the refrigerator door and make sure there are no water leaks coming from the water filter.
A newly installed water filter cartridge may cause water to briefly spurt from the water dispenser. This is due to air getting into the line. It should pose no problem to operation.
PU 01SETTING
Check the amount of water supplied to the ice tray
1. Lift up and pull out the Ice maker bucket in the freezer.
2.When you press the Test button for 3 seconds,
the ice cube container is filled with water from the water supply tap. Put a bowl before you press the test button and check to make sure the amount of water is correct (see the illustration). If the water level is too low, the ice cubes will be small. This is not a problem with the ice maker but of the water pressure in the pipe.
3.In case ice does not come out, pull out the ice bucket and press test button located on the bottom of ice maker.
setting up _21
