BEFORE USING ICEMAKER
Remove- Hold the handle as shown in Figure1.
- Slightly pull up the bottom part. - Take out the ice bucket slowly.
Install- Assemble the icemaker in the reverse order of disassembly.
- Push the bucket in firmly until you hear a clicking sound.
- If the bucket does not fit into its place, turn the gear handle on its back by 90 degrees and reinstall it again as shown in Figure 2.
Before calling service - Any sounds you hear when the ice maker dumps ice into
the bucket are part of normal operation.
- If you don’t dispense ice for a long period of time, the ice may
form clumps in the ice bucket. If ice clumps form, remove the remaining ice and empty the bucket.
-When ice does not come out, check for ice stuck in the chute and remove it.
-When Ice Off blinks on the display panel, CAUTION reinsert the bucket and/or make sure it’s
installed properly.
-When the door is open, the Ice and water dispenser do not work.
-If you close the door hard, it may cause water spilling over the ice maker.
-To prevent dropping the ice bucket, use both hands when removing it.
-To prevent injury, be sure to clean up any ice or
water that may have dropped on the floor.
-Do not let the children hang on the ice dispenser or on the bucket. They may get hurt.
-Be sure not to put your hand or any object into the ice chute. It may cause personal injury or damage mechanical parts.
Removing residual matter inside the water supply line after installing filter.1.Turn ON the main water supply.
2.Press the Water button and push the Dispenser Lever.
3.Flush 1 gallons of water through the filter before use. (Flush approximately 6 minutes.) This will clean the water supply system and remove air from the lines.
12_ setting up
4.Additional flushing may be required in some households.
5.Open the refrigerator door and make sure there are no water leaks coming from the water filter.
Ice 
Water
A newly installed water fi lter cartridge may cause water to briefl y spurt from the water dispenser. This is due to air getting into the line. It should pose no problem to operation.
Check the amount of water suppliedto the ice tray.1.Lift up the icemaker cover and gently pull it out.
2.When you press the Test button for 3 seconds, the ice cube container is filled with water from the water supply tap. Check to make sure the amount of water is correct (see the illustration below). If the water level is too low, the ice cubes will be small. This is a water pressure problem from within the main water pipes, not the refrigerator.
1
Check the
2 water level
Ice maker | Test button |
-It will take a few minutes for the water to
CAUTION | reach the correct level after you push the |
| Test button. |
-Do not press the test button continuously when the tray is filled with ice or water. Water may overflow or ice jamming may occur.
-When the bucket is not installed, the ice maker does not work.
-When Ice Off blinks on the display panel, reinsert the bucket and/or make sure it’s installed properly.