Samsung RSH1NTPE1/XEH, RSH1DTSW1/XEH, RSH1FTIS1/XEH, RSH1DTIS1/XEH, RSH1DTBP1/XEH For Exterior model

4.Remove the filter’s protective cap and then position and insert the filter into the filter housing.

5.Slowly turn the water filter clockwise 90º to align with the indication mark on the cover, locking the filter in position. Make sure that the indicator is lined up with the “lock” position. Remember, do not over-tighten.

Cover filter

Separation	Align the indication
of red cap	mark with lock position

If your model contains wine shelf, you should remove the wine shelf before installing water filters.

Installing the water dispenser line

For Exterior model

Parts for water line Installation

			Purifier lock
Water line fixer	Pipe	Water line	station
			Tightening band
and screws	connector			Purifier

Connecting to the water supply line

Connect the water pipe with coupler and tap.

1.Close the main water tap.

2.Connect coupler “A” to the tap. Note:

WARRANTY INFORMATION

This water line installation is not covered by the refrigerator or ice maker manufacturer’s warranty. Follow these instructions carefully to minimise the risk of expensive water damage.

Note:

If the coupler does not fit on the current tap, go the nearest authorised service dealer and purchase the right couplers fittings.

Select the location where the purifier is to install. (Model with the purifier)

CAUTION

The water line must be connected

to the cold water pipe.

If it is connected to the hot water pipe, it may cause the purifier to malfunction.

COUPLER “A”

TAP

LINE OUTLET

- If you wish to reassemble the water inlet and out-	SIDE OF	90 degree
let sides of the purifier during purifier installation,	PURIFIER
see the reference illustration.	PURIFIER WATER		REFERENCE
- Cut the water line attached to the purifier to the
appropriate place after measuring the distance
between the purifier and the cold water tap.
WATER INLET		COUPLER
SIDE OF PURIFIER

20_ setting up