Samsung RT63PBPN1/XEF operating the, LEVELLing tHE rEfrigErator, sEtting uP tHE rEfrigErator

LEVELLing tHE rEfrigErator

operating the

If the front of the appliance is slightly higher than the rear, the door can be opened and closed more easily.

< Case1 >

Case 1) The appliance tilts down to the left.

< Case2 >

SAMSUNG refrigerator

•Turn the left adjusting leg in the direction of the arrow until the appliance is level.

Case 2) The appliance tilts down to the right.

•Turn the right adjusting leg in the direction of the arrow until the appliance is level.

sEtting uP tHE rEfrigErator

Now that you have your new refrigerator installed and in place, you are ready to set up and enjoy the full features and functions of the appliance.

By completing the following steps, your refrigerator should be fully operational.

If not, first check the power supply and electricity source or try the troubleshooting section at the back of this user guide.

If you have any further questions, contact your Samsung Electronics service center.

1.Place the refrigerator in an appropriate location with reasonable clearance between the wall and the refrigerator.

Refer to installation instructions in this manual.

2.Once the refrigerator is plugged in, make sure the interior light comes on when you open the doors.

3.Set the temperature control to the coldest temperature and wait for an hour.

The freezer should get slightly chilled and the motor should run smoothly.

4.After powering the refrigerator, it will take a few hours to reach the appropriate temperature.

Once the refrigerator temperature is sufficiently cool, you can store food and drink in the refrigerator.

06_ operating

using tHE ControL PanEL (ELECtroniC ConntroL tyPE

1	2
3	4

Speeds up the time needed to freeze products in the freezer.

This can be helpful if you need to quickly freeze items that spoil easily or if the temperature in the freezer has warmed dramatically (For example, if the door was left open).

When you have enough, just press the

1button again to cancel the “Power Freeze” mode. When you use this function, the

POWER	energy consumption will increase.
FREEZE	This function must be activated before
	putting large amount of food stuff in the
	freezer compartment at least 24 hours
	before.
	Adjust the fridge lever to the “COLD”
	position just before activating “Power
	Freeze” mode.
	Otherwise the food in the fridge room can
	be frozen.

Press the Freezer button to set the Freezer

2to your desired temperature, you can

FREEZER set the temperature between -16°C and
	-25°C.
3	By pressing the child lock button for 3
	seconds, all buttons will be locked.
CHILD
	To cancel this function, press the child lock
LOCK
	button again for 3 seconds again.

DA99-01906H-1 EN.indd 6 2010.11.22 3:42:57 PM