6
SAMSUNG
Washing Machine Owner’s Instructions
Washing for the first time
Before washing clothes for the first time, you must run a complete cycle without clothes. To do this:
1. Press the (On/Off) button.
2. Pour a little detergent in the detergent drawer .
3. Turn on the water supply to the washing machine.
4. Press the Temperature button repeatedly until 40 ˚Cis displayed.
5. Press the Start/Pause button.
•This will remove any water from the manufacturer’s test run remaining in the machine.
WM stops the current step of the cycle or does not proceed to the next step of washing (indication of remain time on LED display may increase).
Your new washing machine is equipped with Fuzzy Logic system, which not only sets the optimum
level of water and other parameters of washing, but also controls the washing process as well as
makes necessary corrections in order to provide better washing results.
In the above- mentioned matter, the Fuzzy Logic system has detected deviations in washing cycle such
as: high quantity of detergent at the end of the cycle, high vibration level while spinning, etc.
After detection of such abnormalities, the washing machine is suspending the normal course of
program in order to normalize these parameters and continue the cycle.
Fuzzy logic system makes 7 attempts to eliminate such deviations.
If it is impossible to normalize the above mentioned deviations by
Fuzzy Logic system, you will see the corresponding indication on LED lamps.
(see chapter “Troubleshooting”) The operation of Washing machine that corresponds
to above- mentioned scheme is considered to be normal.
Washing a Load of Laundry
S821-00872a-GB 2/28/03 10:32 AM Page 6