Samsung SCC-B539X manual To install the camera side on a pipe

To install the camera side on a pipe

1.Pull the power and video cables through the pipe connection hole on the camera side

1)Remove the side cover from the Case using a coin or minus (-) driver. (Rotate counterclockwise.)

2)Push the power and video cables stretched outside of the bottom hole into the Case. And pull them out from the side cover of the Case.

2.Attach the removed side cover to the bottom hole and rotate it clockwise using a coin or minus (-) driver. (Be sure to insert the O-ring (P22 T2.4) into the hole before assembly. The ring is necessary for waterproofing.)

3.After pulling the power and video cables through the connection pipe, screw the male thread pipe into the female pipe thread in your camera tightly to fix the Main body. (In this case, be sure to tape with Teflon tape before assembly for waterproofing. Be careful for the wiring cable not to be stuck in the connection area.)

4.Adjust the lens direction. For more information, see page 17, “Adjusting the camera direction.”

5.Attach the Dome cover. For more information, see step 3 in “To install your camera bottom on a pipe” on page 13.

14