camera assembly & mount

1.Dome Base Mounting

-Remove the protecting sheet from the rubber bottom and attach it on the base housing.

-Fix the base housing with the supplied 4pcs of screws(No. 8-32 UNC) on the ceiling or wall.

2.Power Supply & Monitor Impedance (Power supply)

-Adaptor: AC24V / 600mA or DC12V / 800mA (AC24V / DC12V Model)

(Monitor Impedance, if available)

-Set the impedance switch to the 75standard position unless a video equipment is connected to the monitor video out.

3.Camera Module Adjustment (Pan&Tilt Adjustment)

-Adjust the camera direction by turning the pan bracket left or right, the tilt bracket up or down, then fix the screws tight.

(View Angle Adjustment)

-For a wider view angle move the zoom lever to wide, for a narrower view angle move it to tele.

-After accurate adjustment of focal length then adjust the focus lever to near or far for the sharpest focus.

4.Decoration Ring Mounting

-Firmly fix the decoration ring into place with the screws and by using the supplied L-wrench on the base housing.

ENG

camera assembly & mount _05