Connecting the Cables

1.Connect one end of the BNC cable to the VIDEO OUT.

2.Connect the other end of the BNC cable to the VIDEO IN of the monitor.

Video terminals on the back of the monitor

BNC cable

REMOTE RS-485 PWR IN

3.Plug in the power adapter. Use a "minus" screwdriver to connect one part of the power adapter, which consists of two lines, to the POWER terminal of the camera as follows :

POWER SELECTION switch underneath the power adapte

POWER SELECTION

 

switch underneath the

REMOTE RS-485 POWER

 

power adapte

 

4.Determine the type of power supply and set the POWER SELECTION switch accordingly. Next, plug the power adapter into a wall outlet.

The requirements for the power adapter for each model are as follows:

●

SCC-C4205(P) : DC12V 600mA

E

●

SCC-C4305(P) : AC24V 300mA

 

 

DC12V 600mA

 

5.If the camera operates normally, the following screen will be displayed for 5 seconds and then disappears.

PROTOCOL

SAMSUNG

 

 

ADDRESS

0

 

TYPE

RS-485, HALF

 

BAUD RATE

9600

 

LENS

OK

 

EEP VER

1.0

 

ROM VER

1.0

 

 

 

 

6.The requirements for RS485 control is as follows :

●Signaling Speed: 9600 bps

●Data Bit : 8 bits

●Stop Bit : 1 bit

●Parity Bit : none

13

14