Connect antenna cable to antenna signal input terminal of the receiver.
Connect the COMPONENT 1 [COMPONENT IN 1 (Y/PB/ PR)] or [COMPONENT IN 2 (Y/PB/ PR)] input port at the back of
the projector to the Component port at the back of the digital broadcast receiver with the component cable.
- If the digital broadcast receiver provides a PC output port, you can connect a digital broadcast receiver using the [PC
IN] input port of the projector.
When finish connecting the devices, connect the power of the projector and the DTV receiver.
Using the Projector
Turn on the projector and press the [COMP1] button to select <Component 1>.
When connecting the projector and digital broadcasting receiver using a D-SUB cable, select [PC] by pressing <PC> on
the remote control.
Press the [COMP2] button to select <Component 2> if [COMPONENT IN 2] is connected.
When Component Mode is not available, check that the component cables are in place.
- If the receiver is connected to [PC] port, press the [PC] button to select respectively.
Component Ports are marked as (Y/PB/PR), (Y, B-Y, R-Y) or (Y, Cb, Cr) depending on the manufacturer.
Connecting to PC