Caution
If the product generates a strange noise, a burning smell, or smoke, unplug the power plug immediately and contact a service center.
•Failing to do so may result in electric shock or fire.
If the power plug pin or jack is exposed to dust, water or alien substances, clean it thoroughly.
•There is a danger of electric shock or fire.
When cleaning the product, disconnect the power cord and clean the product with a soft dry cloth.
•Avoid using chemicals such as wax, benzene, alcohol, thinner, mosquito- repellent, fragrance, lubrication or cleansing agent when cleaning the product.
This may result in the exterior being deformed or the print being removed.
When not using the product for a long time, such as leaving your home, unplug the power cord from the wall outlet.
•Otherwise, it may cause dust accumulation and result in fire caused by overheating or a short circuit or result in an electric shock.
If the product is installed in a location where the operating conditions vary con- siderably, a serious quality problem may occur due to the surrounding environment. In this case, install the product only after consulting our Call Center.
•Places exposed to microscopic dust, chemicals, too high or low temperature, high humidity, such as airports or stations where the product is continuously used for a long time etc..
If you drop the product or the case is dam- aged, turn the power off and unplug the power cord. Contact a service center.
•Failing to do so may result in fire or electric shock.
Make sure to place your remote control on a table or desk.
•If you step on the remote control, you may fall and hurt yourself or the product may be damaged.
If water or a foreign substance enters the product, turn the product off, unplug the power cord from a wall outlet, and contact a Service Center.
Do not use the product while it indicates a malfunction, such as no sound or no pic- ture.
•Turn the product off immediately, unplug the power cord from a wall outlet, and contact a Service Center.
When a gas leak occurs, do not touch the product or the power plug and ventilate immediately.
•A spark may result in an explosion or fire.
•During a thunder or lighting storm, do not touch the power cord or antenna cable
Do not touch the lens on the product.
•This may cause damage to the lens.
Do not touch any outer part of the product with tools such as a knife or a hammer.
To clean dirt or stains on the front projection lens, use spray or a wet cloth dampened with neutral detergent and water.
Ask a Service Center to clean the interior of the projector at least once per year.
Major Safety Precautions |