Samsung SRP-352plusA&C - page 11

Rev. 1.06 - 11 -
SRP-350/352plusA&C
1-4 Setting the Dip Switches
1-4-1 Serial Interface (RS-232C)
• DIP Switch 1
SW Function ON OFF Default
1-1 Auto Line Feed Enable Disable OFF
1-2 Handshaking XON/XOFF DTR/DSR OFF
1-3 Data Length 7bits 8bits OFF
1-4 Parity Check Yes No OFF
1-5 Parity Selection EVEN ODD OFF
1-6 OFF
1-7 ON
1-8
Baud Rate Selection
(bps) Refer to the following table 1 OFF
• DIP Switch 2
SW Function ON OFF Default
2-1 Reserved - - OFF
2-2 Internal bell control Internal bell
disable Internal bell enable OFF
2-3 Auto Cutter Disable Enable OFF
2-4 BUSY Condition Receive Buffer Full * Offline * Receive Buffer
Full OFF
2-5 OFF
2-6 OFF
2-7 Print Density Refer to the following table 2 OFF
2-8 Near-End Sensor Status Disable Enable OFF
1-4-2 Parallel & USB2.0 Interface
• DIP Switch 1
SW Function ON OFF Default
1-1 Auto Line Feed Enable Disable OFF
1-2
~
1-6 Reserved - - OFF
1-7 Reserved - - ON
1-8 Reserved - - OFF
• DIP Switch 2
SW Function ON OFF Default
2-1 Reserved - - OFF
2-2 Internal bell control Internal bell
disable Internal bell enable OFF
2-3 Auto Cutter Disable Enable OFF
2-4 BUSY Condition Receive Buffer Full * Offline * Receive Buffer
Full OFF
2-5 OFF
2-6 OFF
2-7 Print Density Refer to the following Table 2 OFF
2-8 Near-End Sensor Status Disable Enable OFF