8. Complete the installation of the water dis- penser line.
1) Switch on the fridge/freezer and press the lever on the left of the dispenser until water runs out through the water tube (approximate- ly two to three minutes).
(Press it until all air has been empty.)
2) At this time, check for any possible leakages at the joins in the water tube.
After securing the water tube, move the fridge/freezer to the required location.
Once the fridge/freezer is in position, move it as little as possible.
9. Check the volume of water supplied to the ice maker.
1) Remove the upper ice maker from the refrig- ICE MAKER 
erator.
2)When you press the test button, the ice cube container is filled with water from the water supply tap for the ice maker. Check the amount of water (see the illustration below). If there is too little water, the ice cubes will be small inacceptably. This is not a problem with the fridge/freezer but with the water pressure in the pipe and occurs frequently. When this problem occurs, use the following method to check the volume of water supplied.
CHECK THE WATER SUPPLIED
TEST BUTTON 
TOO MUCH
OPTIMUM
LEVEL
TOO LITTLE
14
