INSTALLING THE WATER DISPENSER LINE
Connect the water line to the refrigerator.
- Remove the compressor cover of the refrigerator. | WATER LINE |
| |
- Connect the water line to the valve, as shown in the figure. |
|
- When connected, check if there is any leakage. |
|
If any, repeat the connection. |
|
- Reattach the compressor cover of the refrigerator. |
|
CONNECTION NUT
COMPRESSOR COVER OF REFRIGERATOR
Secure the water line.
- Using clip ”A”, fix the water line to the wall (the back of refrigerator). |
|
|
|
|
- When the water line is secure, make sure whether the |
|
|
|
|
water line is not excessively bent, pinched or squashed. | CLIP A |
|
|
|
Complete the installation of the water supply line. |
|
|
| |
|
|
| ||
|
|
|
| |
- Power on the refrigerator and press the lever on the right of the |
|
|
|
|
dispenser until water runs out through the water line and all air has been empty. | WATER LINE |
|
| |
- At this time, check for any possible leakages at the join point in the water line. |
|
| ||
| ||||
|
|
|
| |
After securing the water line, move the refrigerator to the required location. |
|
|
|
|
Once the refrigerator is in position, do not move possibly. |
|
|
|
|
Install the water filter.
-As shown, separate the fixed cap in the refrigerator by rotating it counterclockwise.
Remove the water filter from the box and put a month indicator sticker on the filter as shown.
-Write the month you installed the filter on the label. EX) If the water filter was installed in March, put “MAR”
-Remove the protective cap then position and insert the filter as shown,
-Slowly turn the water filter clockwise 90º to align the indication mark on the
cover, locking the filter in postion. Do not overtighten.
SEPARATION
OF RED CAP
STICKER
(MONTH INDICATION)
COVER FILTER
ALIGN THE INDICATION MARK WITH LOCK POSITION.
INSTALLATION INSTRUCTIONS
CAUTION Please check if the indication line aligns with the lock position.
31
