Samsung SU-2900 M a i n t e n a n c e, The belt, When to replace, How to replace, 3-10, 3-11

	M a i n t e n a n c e
The belt	3-7	3-8
The belt on your cleaner causes the
agitator to rotate and is important for
the effective operation of the
cleaner. The belt is located under
the bottom plate of the cleaner and
should be checked from time to time
to be sure it is in good condition.
When to replace

Disconnect cleaner from	How to replace	Remove agitator and used belt.
electrical outlet.	Disconnect cleaner from electrical	Discard used belt.
To check belt, remove bottom plate	outlet.
	Place handle in low position and turn
as shown in “How to replace.”
	cleaner over so bottom side is up.
Replace belt if it is stretched, cut or
	Remove the 4 screws as shown with
broken.
	a screw driver.

3-9

With lettering on outside of belt and positioned as shown in box on (D), slide new belt over motor pulley (B).

3-10

Insert agitator through belt and place belt in belt guide (C) on agitator.

Should the agitator shield (D) become dislodged while replacing the belt or the agitator, reposition it as shown, noting the placement of its belt guide (D)

3-11

Grasp agitator firmly and fit it into position by first sliding the end opposite the belt into the rectangular slot (F) on side of cleaner.

Pull other side of agitator (G) into place. Turn agitator, making sure belt is not pinched between agitator and agitator shield.

3-12

Reposition bottom plate and 4 screws. Tighten screws securely.

When to replace the agitator brush roll

When agitator brushes are worn, the agitator should be replaced.

To check condition of brushes, disconnect cleaner from electrical outlet.

Move the edge of a card across bottom plate while turning agitator. To maintain cleaning effectiveness, replace agitator if brushes do not touch card.

3-13

How to replace

Disconnect cleaner from electrical outlet.

Remove bottom plate, belt and agitator following directions in “The belt” section beginning with Fig. 3-10.

Discard old agitator.

Continue following the directions in “The belt” section to reposition belt, new agitator and bottom plate.

5