5
1.
Place a rag under washer filter not to wet the floor.
2.
Turn the filter-cap to the left.
3.
Take out the filter and remove any sludge.
4. Reassemble in reverse order.
If the filter net is clogged after washing, lift up the net
Remove the collected lint and rinse the filter net.
CLEANING THE FILTER NET
● When a proper amount of fabric softener is stored

in the box, it is automatically added in at the

final rinse cycle.

❋In case the hot water only is connected,

this function will not be operated.

HOW TO ADD THE DETERGENTHOW TO ADD THE FABRIC SOFTENER
● When the manufacturer’s recommended amount per
load of fabric softener is stored in the softener inlet,
it will be automatically dispensed during the final rinse
cycle.
❋Before operating the washing machine, make
sure that any water remaining in softener dispenser
from a previous load is removed.
Only For models with polypropylene(plastic) wash bowl
CLEANING THE FILTER (pump drained washer)
LEVELLING
1. Pull down the adjusting handles of
the adjusting feet which are located
at the right and left of the front side.
2. Adjust the height of the
machine upwards or downwards.
3. When the adjustment is finished,
push back the handles to fix the
adjusting feet.
NOTE
Do not kick or step on the adjusting
handles.
1.
Open the detergent box
by pulling in the direction of the
arrow as shown in the figure.
2.
Add the amount of detergent for one
washing evenly in the box so that the
detergent does not overflow the box.
❋When too much softener is stored above the
base line, it may not be operated properly.
SEE IF THE MACHINE IS PLACED LEVEL BY CHECKING
THE POSITION OF THE WASHING TUB.
● Open the lid of the machine, pour water into the tub up
to the level just below the pulsator, and adjust the legs
so that the pulsator is positioned at the center of the
water as shown in the figure.
● Place the machine more than 10cm away from the wall.
SW65ASP2-00967A-eQuark 7/11/02 3:23 PM Page 5