CLEANING THE FILTER NET
1. Push the upper part of | 2. Open the cover as | |||
the filter and pull in. | shown in the figure. | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
HOW TO ADD THE FABRIC SOFTENER
When a proper amount (one time does) of fabric softener is stored in the softener inlet,it is automatically put in at the last rinsing cycle.
Do not use detergent, bleach or starch into the Softener Inlet.
Using too much softener may produce unsatisfactory results.
3. Clean the filter. | 4. Close the cover and insert the lower | ||
| part of the filter in the basket first and | ||
| then push the filter with "click" sound . | ||
|
|
|
|
|
|
|
|
Do not open the lid during the Spin Dry cycle.
If added too early, its effectiveness will decrease.
Do not leave the softener
into the Softener Dispenser for a long time. Because softner became stiff.
HOW TO PUT THE DETERGENT IN
1.Open the detergent box by pulling in the direction of the arrow as shown in the figure and then put the powder detergent in the detergent box.
2.Put in
Detergent Device
Put the detergent in proportion to water level
Caution : If softener is stored over the above base line, it may flow down at any time.
CLEANING THE FILTER (pump drained washer) | LEVELLING |
1.Place a rag under washer filter not to wet the floor.
2.Turn the
3.Take out the filter and remove any sludge.
4.Reassemble in reverse order.
•If the washer is not leveled with the ground, it makes the machine tremble more or be out of order. So, make sure that the washer is leveled properly.
SEE IF THE MACHINE IS PLACED LEVEL BY CHECKING THE POSITION OF THE WASHING TUB.
Open the lid of the machine, pour water into the tub up to the level just below the pulsator, and adjust the legs so that the pulsator is positioned at the center of the water as shown in the figure.
Place the machine more than 10cm away from the wall.
Adjust the legs on feet | Water |
|
for levelling .
Loosen 
Lock
5
