4
INSTALLATION & MAINTENANCE

ENVIRONMENT

Leave some space

Maintain at least 10cm between the washer and
the wall.

Place the washer on a sturdy flat

surface.

If the washer is placed on an uneven or weak
surface, noise or vibration occurs. (Allowable
slope is 1 degree)

Never install the washer in a very

steamy environment or where it might

be open to the rain.

Excessive moisture may cause an electrical
shock hazard.

Avoid direct sunlight or heaters.

As plastic and electrical components are affected
by direct heat,never place the washer near
furnaces, boilers,etc. Do not place under direct
sunlight.

IN CASE OF PUMP-DRAINED WASHER

•Be sure to join tightly the
drain hose into the drain-
outlet on the back of the
machine.
•Install the drain hose in
the position of about
70~80 cm above the
ground.
a
b
c
c
1.Remove the adaptor from the
water supply hose.
2.First,using a "+" type screw
driver, loosen the four screws
on the adaptor. Next,take the
adaptor and turn part(b)
following the arrow for gap
about 5mm between them.
3.Connect adaptor to the water
tap by tightening the screws
firmly.
Then,turn part (b) following the
arrow and put (a) and (b)
together.
5.Connect the other end of the
water supply hose to the inlet
water valve at the top of the
washer.
Screw the hose clockwise all
the way in.
6.If the water tap is a screw
type,assemble a water supply
hose that fits to the tap as
shown.
4.Connect the water supply hose
to the adaptor. Pull down the
part (c) of the water supply
hose. When you release part (c)
the hose is automatically
connects to the adaptor making
a 'click' sound.

HOW TO CONNECT WATER SUPPLY HOSE

Check the type of tap fitting which is in your laundry and then see appropriate instruction below:

A tap of ordinary type is desirable In case of square tap

●
Take out the internal part of the connector
and join it in the following way.
ORDINARY TAP SQUARE TAP ROTATING TAP Internal part
Note : The appliance is to be connected to the water mains using new hose-sets and that old hose-sets should not
be used.