DESCRIPTION AND /CLEANING OF PARTS
INNER LID
DRAIN HOSE
(with pump)
OVERFLOW
FILTER
LINT FILTER This is used for gathering the dregs made during washing.
WASH TUB LID
Be sure to keep the lid closed during washing and spinning.
SPIN DRYER LID When you open this
lid while the spin basket is spinning,the spinning will be stopped by the brake system.
SPIN DRYER BASKET
POWER CORD The plug’s shape
may not be similar to that shown in this drawing.
WATER DRAIN HOSE
(without pump)
EARTH WIRE
CLEANING THE FILTER
•Pull the overflow filter out and take up the filter by removing 3 screws as shown in figure. Wash the filter and
washing tub.
CLEANING THE FILTER
•Push the strainer(filter) out and take
up the filter as shown in figure. Wash the filter and washing tub.
DRAIN FILTER
In case of incomplete drain, disassemble the drain filter with screw driver(+), and remove lints from the filter as shown in the filter as shown in
the figure.
HOW TO CLEAN THE FILTER (In case drain pump)
PULSATOR |
| WASH TUB |
|
|
|
| |
CONTROL LEG |
| DRAIN FILTER |
|
|
|
| |
CLEANING THE LINT FILTER | OVERFLOW FILTER | OVERFLOW FILTER |
|
• If the dregs are piled up in the | • Pull the upper side of the | Pull the upper side of the | A |
lint filter after finishing the wash, | overflow filter with your | overflow filter with | |
push down and | fingers into the holes | two fingers inserted into |
|
pull it out as | in the direction of | hole ‘A’ in the |
|
shown in the | arrow as shown | direction of arrow |
|
figure. | in the figure. | as shown in the figure. |
|
• Wash the filter |
|
|
|
net in water. |
|
|
|
1.Place a rag under the washer filter not to wet the floor.
2.Rotate the filter counterclockwise and pull out the filter.
3.Remove dirts and
rotate the filter clockwise until it locks in position.
CLEANING THE WASH TUB
First, fill water in the wash tub to ‘L’ level( 
, then drain water from the wash tub simultaneously with operating wash cycle for 1~2 minutes. • Close the wash tub lid.
2
