Cooling Your Room
You must select the Cool mode if you wish to adjust the: ◆ Cooling temperature
◆ Fan speed when cooling
1 If necessary, press the 
(On/Off) button.
Result: | ◆ The 5 Way indicator on the indoor unit lights up. |
| ◆ The air conditioner starts up in the mode selected |
| when the unit was last used. |
| ◆ The indoor unit beeps. |
IMPORTANT The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being:
◆Plugged in
◆Stopped
lt will start up normally after three minutes.
2If the 
is not displayed at the top of the remote control,
press the MODE button on the remote control one or more times until it appears.
Result: ◆ | The indoor unit beeps each time you press the MODE button. |
◆ | The air conditioner runs in COOL mode. |
Note You can change modes at any time.
3To adjust the temperature, press the TEMPERATURE buttons one or more times until the required temperature is displayed.
Possible temperatures are between 18°C and 30°C inclusive.
Result: ◆ Each time you press the TEMPERATURE buttons:
-The temperature is adjusted by 1°C
-The indoor unit beeps
◆The air conditioner starts cooling, provided that the room temperature is higher than the selected temperature; the fan will, however, operate.
4Select the fan speed by pressing the FAN button one or more times until the required setting is displayed:
Automatic (rotated :
)
Low
Medium
High
Result: Each time you press the FAN button, the indoor unit beeps.
5To control the direction of the air flow, refer to page 16 and 17.
