■HOW TO ADD THE FABRIC SOFTENER 
•When a proper amount (one time does) of fabric softener is stored in the softener inlet, it is automatically put in at the last rinsing cycle.
•Do not use detergent, bleach or starch into the Softener Inlet.
•Using too much softener may produce unsatisfactory results.
•Do not open the lid during the Spin Dry cycle. If
added too early, its effectiveness will decrease.
•Do not leave the softener into the Softener. Dispenser for a long time. Because softner became stiff.
■HOW TO PUT THE DETERGENT IN 
1.Open the detergent box by pulling in the direction of the arrow as shown in the figure and then put the powder detergent in the detergent box.
2.Put in
Detergent Device
Put the | •••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• | ||
detergent in proportion | •••••••• | •••••••••• | |
|
| ||
to Water level
Softener Device
Softener baseline
CAUTION : If softener is stored over the above base line, it may flow down at any time.
■WATER SUPPLY CONNECTOR FILTER
■CLEANING THE FILTER 
Clean the filter net often to keep the washer clean.
1. Push the upper part of the Magic 1. Push up and pull out the filter net. filter and pull in.
2.Open the cover as shown in the 2. Remove the collected lint from the
figure. | filter net. |
3. Clean the Magic filter. | 3. Clean the filter net. |
4. Close the cover and insert the | 4. Pull down the filter net. |
lower part of the filter in the |
|
basket first and then push the |
|
filter with “click” sound. |
|
■HOW TO CLEAN THE PUMP FILTER 
1.Pull out the filter and wash well.
inlet water valve
2.Pull in the filter and connect the hose to the inlet water valve tightly.
3.Check if there is a leakage.
Note to tighten up the connector.
1. Place a rag under the washer filter not to wet the floor.
2. Rotate the filter counterclockwise and pull out the filter.
3. Remove dirts and rotate the filter clockwise until it locks in position.
- 12 -
