installation & maintenance
CAUTIONS WHEN INSERTING THE DRAIN HOSE
Less than 3 m
1.Don’t exceed more than 3 m when the 2. Be careful to drain water out at the end of
drain hose is used by connecting with | the drain hose. |
other hoses. |
|
Less than 3 m
Less than 5 cm
3.The doorsill shoudn’t be more than 5cm. 4. Don’t install the drain hose underneath the wash machine.
Test run
Make sure that you install your washing machine correctly by running the Rinse+Spin cycle after the installation is complete.
ADDING DETERGENT
1. Open the detergent drawer and then add the powder detergent into the detergent compartment.
2. Add detergent evenly so that it doesn’t brim over the
edge of the drawer.
• Use a reasonable amount of detergent. If you use more detergent than the standard
quantity or the water temperature is too low and the detergent does not dissolve in the water completely
causing it to remain on the laundry and in the hose and tub, it may cause damage such as dirtying and discoloring the laundry.
•If you use a powder detergent and it remains on the laundry, it may cause a bad odor. Rinse the laundry suffi ciently in fresh water.
If you spread a powder detergent over the laundry directly, it may result in discoloration. CAUTION Make sure to insert it into the detergent compartment.
If the water pressure is low, the detergent may remain in the detergent compartment.
ADDING FABRIC SOFTENER
1.When the proper amount (one time dose) of fabric softener is stored in the softener inlet, it is automatically added during the last rinse cycle.
2.Do not add detergent, bleach or starch into the softener inlet.
3.Using too much softener may produce unsatisfactory results.
4.Do not open the lid during the Spin cycle. If added too early, its effectiveness will decrease.
5.Do not leave the softener in the softener dispenser for a long time as it may congeal.
If the water pressure is low, the fabric softener may remain in the softener compartment. In this case, put the fabric softener into the tub directly.