ASSEMBLING THE RAT PROTECTION PANEL
Tilt the washer a little and lift up the panel until it clicks, finally fix the panel with screw to the base as shown in the figure.
1.Insert the sound absorbing panel to the assembling hole on back side to the end.
2.If you have difficulty inserting the panel lift up the washer a little and insert it
IN CASE OF PUMP-DRAINED WASHER
Take out the
Be sure to join tightly the drain hose into the
Be sure to join tightly the drain hose into the
Install the drain hose in the position of about 90~100cm above the ground.
90~100cm
CONNECTING THE DRAIN HOSE | (a) |
After pressing the joint ring(a), insert the drain hose(b) |
|
to drain direction. |
|
(b)
HOW TO ADD THE FABRIC SOFTENER 
•When a proper amount (one time does) of fabric softener is stored in the softener inlet,it is automatically put in at the last rinsing cycle.
•Do not use detergent, bleach or starch into the Softener Inlet.
•Using too much softener may produce unsatisfactory results.
•Do not open the lid during the Spin Dry cycle.
If added too early, its effectiveness will decrease.
•Do not leave the softener into the Softener Dispenser for a long time.
Because softner became stiff.
HOW TO PUT THE DETERGENT IN
1.Open the detergent box by pulling in the direction of the arrow as shown in the figure and then put the powder detergent in the detergent box.
2. Put in
Detergent Device
Put the detergent in proportion to water level
Softener Device Softener baseline 
CAUTION : If softener is stored over the above base line, it may flow down at any time.
8
