
Troubleshooting
Troubleshooting
| 
 | Problem | 
 | Action | 
| 
 | 
 | 
 | |
| 
 | 
 | • Fully open both taps. | |
| 
 | 
 | • Make sure the temperature selection is correct. | |
| 
 | 
 | • Make sure the hoses are connected to the correct taps. Flush | |
| 
 | 
 | 
 | water lines. | 
| 
 | 
 | • Make sure the water heater is set to supply a minimum | |
| 
 | 
 | 
 | 120 °F (49 °C) hot water at the tap. Also, check the water | 
| 
 | 
 | 
 | heater capacity and recovery rate. | 
| 
 | 
 | • Disconnect the hoses and clean the mesh filter. The mesh filter | |
| 
 | Fills with the wrong | 
 | may be clogged. | 
| 
 | water temperature. | • | While the washing machine fills, the water temperature may | 
| 
 | 
 | 
 | change as the automatic temperature control feature checks | 
| 
 | 
 | 
 | incoming water temperature. This is normal. | 
| 
 | 
 | • | While the washing machine fills, you may notice just hot and/ | 
| 
 | 
 | 
 | or just cold water going through the dispenser when cold or | 
| 
 | 
 | 
 | warm temperatures are selected. | 
| 
 | 
 | 
 | This is a normal function of the automatic temperature | 
| 
 | 
 | 
 | control feature as the washing machine determines the water | 
| 
 | 
 | 
 | temperature. | 
| 
 | 
 | 
 | |
| 
 | 
 | • Use the High or Extra High spin speed. | |
| 
 | Load is wet at the | • | Use high efficiency (HE) detergent to reduce oversudsing. | 
| 
 | • | Load is too small. Small loads (one or two items) may become | |
| 
 | end of a cycle. | ||
| 
 | 
 | unbalanced and not spin completely. | |
| 
 | 
 | 
 | |
| 
 | 
 | • Make sure the drain hose is not kinked or clogged. | |
| 
 | 
 | 
 | |
| 
 | 
 | • Make sure the door is properly closed. | |
| 
 | 
 | • Make sure all hose connections are tight. | |
| 
 | Leaks water. | • Make sure the end of the drain hose is correctly inserted and | |
| 
 | 
 | secured to the drain system. | |
| 
 | 
 | 
 | |
| 
 | 
 | • | Avoid overloading. | 
| 
 | 
 | • | Use high efficiency (HE) detergent to prevent oversudsing. | 
| 
 | 
 | 
 | |
| 
 | 
 | • Excessive suds collect in recesses and can cause foul odours. | |
| 
 | Has odours. | • Run cleansing cycles to sanitize periodically. | |
| 
 | • | Clean the door seal (diaphragm). | |
| 
 | 
 | ||
| 
 | 
 | • Dry the washing machine interior after a cycle has finished. | |
| 
 | 
 | 
 | 
 | 
| 
 | No bubbles are seen | • | Overloading may screen bubbles. | 
| 
 | (Bubbleshot models | ||
| 
 | • | Severely contaminated laundry may not generate bubbles. | |
| 
 | only). | ||
| 
 | 
 | 
 | |
| 
 | 
 | 
 | 
 | 
| 54 | English | 
 | 
 | 
2018/3/8 15:04:12
