washing a load of laundry
7 | Start/Pause | Press to pause and restart programs. | |
button | |||
|
| ||
|
| Press once to turn the washing machine on, press again to turn the washing | |
8 | (On/Off) | machine off. | |
button | If the washing machine power is left on for longer than 10 minutes without | ||
|
any buttons being touched, the power automatically turns off.
What is the “Child Lock” function?
•If you press the “Child Lock” button (Spin+Option ( 
+ 
) button) longer than 2 sec during operation, this function is selected.
•If once this function is selected, no change can be done until the end of laundry.
•Press the “Child Lock” button (Spin+Option ( 
+ 
) button) longer than 2 sec to cancel the function.
WM STOPS THE CURRENT STEP OF THE CYCLE OR DOES NOT PROCEED TO THE NEXT STEP OF WASHING (INDICATION OF REMAIN TIME ON LED DISPLAY MAY INCREASE).
Your new washing machine is equipped with Fuzzy Logic system, which not only sets the optimum level of water and other parameters of washing, but also controls the washing process as well as makes necessary corrections in order to provide better washing results. In the above- mentioned matter, the Fuzzy Logic system has detected deviations in washing cycle such as: high quantity of detergent at the end of the cycle, high vibration level while spinning, etc.You can adjust existing wash programs, i.e. change wash temperature and spin speed. After detection of such abnormalities, the washing machine is suspending the normal course of program in order to normalize these parameters and continue the cycle. Fuzzy logic system makes 7 attempts to eliminate such deviations. If it is impossible to normalize the above mentioned deviations by Fuzzy Logic system, you will see the corresponding indication on LED lamps. (see chapter “Troubleshooting”) The operation of Washing machine that corresponds to above- mentioned scheme is considered to be normal.
WASHING FOR THE FIRST TIME
Before washing clothes for the first time, you must run a complete cycle without clothes.
To do this:
1.Press the 
(On/Off ) button.
2. Pour a little detergent in the detergent drawer 
.
3.Turn on the water supply to the washing machine.
4.Press the Temperature button repeatedly until 40˚C is displayed.
5.Press the Start/Pause button.
•This will remove any water from the manufacturer’s test run remaining in the machine.
PUTTING DETERGENT IN THE WASHING MACHINE
1.Pull out the detergent drawer.
2.Add laundry detergent into compartment 
.
3.Add softener into compartment 
(if you desire).
4.Add prewash detergent into compartment 
(if you desire).
10_ Washing a load of laundry
