Washing a Load of Laundry
Washing clothes manually
You can wash clothes manually without using the Fuzzy Logic feature. To do so:
1.Turn on the water at the water source sink.
2.Press the (
) (On/Off) button on the washing machine.
3.Open the door.
4.Load the articles one at a time loosely into the drum, without overfilling.
5.Close the door.
6.Put the detergent and, if necessary, softener or chlorine bleach, in the appropriate compartments.
7.Press the Wash/Rinse Temperature button to select the water temperature. (Hot/Warm ➝Hot/Cold ➝Warm/Warm ➝Warm/Cold ➝Cold/Cold )
8.Press the soil level button to select the spin speed for the load. (Very Heavy ➝Heavy ➝Normal ➝Light ➝Very Light)
9.Press the Spin button to select the spin speed, [Extra high ➝High ➝Medium ➝Low ➝No Spin]. Notice: The rinse hold program allows you to take clothes that are dripping wet out of the
washing machine.
no : No Spin, rh : Rinse Hold.
10.Press the button repeatedly to cycle through the available delayed start options (from 4 hour to 24 hours in one hour increments). Displayed hours means the time of finished
11.Press the Start/Pause button and the machine will begin the cycle.
When the cycle is finished:
1.Open the door.
Notice: The door will not open until 3 minutes after the machine stops or the power turns off.
2.Remove laundry.
Using delay start
You can set the washing machine to finish your wash automatically at a later time, choosing from 4 to 24 hour delay (in 1 hour increments). Displayed hours means the time of finished
To do this:
1.Manually or automatically set your washing machine for the type of clothes you are washing.
2.Press the Delay Start button repeatedly until the delay time is set.
3.Press the Start/Pause button. The Delay Start indicator will light, and the clock will begin counting down until it reaches your finish time.
4.To cancel Delay Start, press the (
) (On/Off) button, then turn the washing machine on again.
SAMSUNG Washing Machine Owner’s Instructions
