PROBLEM | ACTION | ||
|
|
| |
| • | Press or tap Start/Pause to stop the washing machine. | |
| • | It may take a few moments for the door lock mechanism to disengage. | |
| • | The door will not open until 3 minutes after the washing machine has | |
|
| stopped or the power turned off. | |
The door does not open. | • | Make sure all the water in the drum is drained. | |
| • | The door may not open if water remains in the drum. Drain the drum and | |
|
| open the door manually. | |
| • | Make sure the door lock light is off. The door lock light turns off after the | |
|
| washing machine has drained. | |
| • | Make sure you use the recommended types of detergent as appropriate. | |
| • | Use high efficiency (HE) detergent to prevent oversudsing. | |
Excessive suds. | • | Reduce the detergent amount for soft water, small loads, or lightly soiled | |
|
| loads. | |
| • | ||
Cannot apply additional | • | Make sure the remaining amount of detergent and fabric softener is not | |
detergent. |
| over the limit. | |
| • | Plug the power cord into a live electrical outlet. | |
| • | Check the fuse or reset the circuit breaker. | |
| • | Close the door and press the Start/Pause button to start the washing | |
|
| machine. For your safety, the washing machine will not tumble or spin | |
|
| unless the door is closed. | |
| • | Before the washing machine starts to fill, it will make a series of clicking | |
Stops. |
| noises to check the door lock and does a quick drain. | |
• | There may be a pause or soak period in the cycle. Wait briefly and the | ||
| |||
|
| washing machine may start. | |
| • | Make sure the mesh filter of the water supply hose at the water taps are | |
|
| not clogged. Periodically clean the mesh filter. | |
| • | If the washing machine is not supplied with sufficient power, the washing | |
|
| machine temporarily will not drain or spin. As soon as the washing | |
|
| machine regains sufficient power, it will operate normally. | |
| • | Fully open both taps. | |
| • | Make sure the temperature selection is correct. | |
| • | Make sure the hoses are connected to the correct taps. Flush water lines. | |
| • | Make sure the water heater is set to supply a minimum 120 ˚F (49 ˚C) hot | |
|
| water at the tap. Also, check the water heater capacity and recovery rate. | |
Fills with the wrong water | • | Disconnect the hoses and clean the mesh filter. The mesh filter may be | |
| clogged. | ||
temperature. | • | While the washing machine fills, the water temperature may change | |
| |||
|
| as the automatic temperature control feature checks incoming water | |
|
| temperature. This is normal. | |
| • | While the washing machine fills, you may notice just hot and/or just cold | |
|
| water going through the dispenser when cold or warm temperatures are | |
|
| selected. This is a normal function of the automatic temperature control | |
|
| feature as the washing machine determines the water temperature. | |
|
|
| |
English - 36
|
| ||
|
| ||
|
|
|
|