Installing the Washing Machine
Connecting the water supply hose
1. Remove the adaptor from the |
|
| 4. Connect the water supply hose to the |
water supply hose. |
|
| adaptor. Pull down part (c) of the |
|
| c | water supply hose. When you release |
|
| part (c) the hose automatically connects | |
|
|
| |
|
|
| to the adaptor making a ’click’ sound. |
2. First, using a “+” type screw driver, |
|
| 5. Connect the other end of the water |
loosen the four screws on the adaptor. |
|
| supply hose to the inlet water valve at |
Next, take the adaptor and turn part(b) |
|
| the top of the washer. Screw the hose |
following the arrow until there is a 5mm |
|
| clockwise all the way in. |
gap. |
|
|
|
3. Connect adaptor to the water tap by |
|
| • If the water tap has a screw type faucet, |
tightening the screws firmly. |
|
| connect the water supply hose to the |
Then, turn part (b) following the arrow | a |
| tap as shown. |
and put(a) and (b) together. | b |
|
|
|
|
|
NOTICE After completing connection, if water leaks from the hose, then repeat the same steps. Use the most conventional type of faucet for water supply. In case the faucet is square or too big, remove the spacing ring before inserting the faucet into the adaptor.
Note: The appliance is to be connected to the water mains using new
Drain hose connection procedures
1. Holding down the handle of the drain hose connector, put in the drain hose in desired direction.
: Fix the hose into the drainage hole, and give the hose connector a push to the body to fix the hose.
Positioning the drain hose
The end of the drain hose may be positioned in three ways:
Over the edge of a wash basin.
The drain hose must be placed at a height of between 0 and 90 cm. To keep the drain hose spout bent, use the supplied plastic hose guide. Secure the guide to the wall with a hook or to the faucet with a piece of string to prevent the drain hose from moving.
ln a sink drain pipe branch
The drain pipe branch must be above the sink siphon so that the end of the hose is at least 60 cm above the ground.
ln a drain pipe
Samsung recommends that you use a 65 cm high vertical pipe; it must be no shorter than 60 cm and no longer than 90 cm.
SAMSUNG Washing Machine Owner | ’ s Instructions | 5 |
