Installing the Washing Machine

Connecting the water supply hose

1. Remove the adaptor from the

4.

Connect the water supply hose to

water supply hose.

 

the adaptor. Pull down part (c) of

 

c

the water supply hose.

 

When you release part (c) the

 

 

 

 

hose automatically connects to the

 

 

adaptor making a 'click’ sound.

2. First, using a ‘+’ type screw driver,

5.

Connect the other end of the water

loosen the four screws on the

 

supply hose to the inlet water

adaptor. Next, take the adaptor

 

valve at the top of the washer.

and turn part(b) following the

 

Screw the hose clockwise all the

arrow until there is a 5mm gap.

 

way in.

3. Connect adaptor to the water tap

If the water tap has a screw type

by tightening the screws firmly.

a

faucet, connect the water supply

Then, turn part (b) following the

b

hose to the tap as shown.

arrow and put(a) and (b) together.

 

 

NOTICE After completing connection, if water leaks from the hose, then repeat the same steps. Use the most conventional type of faucet for water supply. In case the faucet is square or too big, remove the spacing ring before inserting the faucet into the adaptor.

Note: The appliance is to be connected to the water mains using new hose-sets and that old hose-sets should not be used.

Drain hose connection procedures

1.Holding down the handle of the drain hose

connector, put in the drain hose in desired direction.

: Fix the hose into the drainage hole, and give the hose connector a push to the body to fix the hose.

Positioning the drain hose

The end of the drain hose may be positioned in three ways:

Over the edge of a wash basin.

The drain hose must be placed at a height of between 0 and 90 cm. To keep the drain hose spout bent, use the supplied plastic hose guide. Secure the guide to the wall with a hook or to the faucet with a piece of string to prevent the drain hose from moving.

ln a sink drain pipe branch

The drain pipe branch must be above the sink siphon so that the end of the hose is at least 60 cm above the ground.

ln a drain pipe

Samsung recommends that you use a 65 cm high vertical pipe; it must be no longer than 90 cm.

SAMSUNG Washing Machine Owner’s Instructions 5

Page 7
Image 7
Samsung WM1255AGS/YLE manual Drain hose connection procedures, Positioning the drain hose