INSTALLATION
ENVIRONMENT | HOW TO CLEAN THE FILTER (In case drain pump) | ||||
Leave some space | 1. | Place a rag under the washer filter | |||
| not to wet the floor. | ||||
Space at last 15cm between the washer | 2. | Rotate the filter counterclockwise | |||
and the wall. |
| and pull out the filter. | |||
Place the washer on a sturdy flat surface. | 3. | Remove dirts and rotate | |||
| the filter clockwise until it | ||||
If the washer is placed on an uneven or weak |
| locks in position. | |||
surface, noise or vibration may be occured. |
| Remark : Should be cleaned |
|
|
|
(Allowable is 2°) |
| Filter at least 1 time a week. |
|
|
|
|
|
| |||
Never install the washer near water. | CONNECTING THE DRAIN HOSE |
Do not place the washer in steamy rooms or | Insert the drain hose(a) and push it tighly to be |
where the washer is directly exposed to rain. | connected as arrow direction. |
Moisture may destroy the electrical insulation |
|
and cause an electrical shock hazard. |
|
Avoid direct sunlight or heating devices. As plastic and electrical components are affected by direct heat, never place the washer near heaters, boilers,etc.
Do not place under direct sunlight.
CHANGING THE POSITION OF THE DRAIN HOSE Before attempting to change the position of the drain hose, disconnect the plug from the outlet.
1.Route the drain hose inside the machine.
2.Take out the drain hose from the opposite hole and insert the drain hose into the hose holder.
(WITHOUT PUMP)
Install the drain hose(A) about 70~80cm above the ground for pump model.
CLEANING THE MACHINE 
CLEANING THE LINT FILTER
If the dregs are filled up in the lint filter after finishing the wash, push down(1) and pull it out(2) as shown in figure.
Remove the collected lint and rinse the filter net.
CLEANING THE WASH TUB
Wipe off strains on the cabinet and operation panel with soft cloth. Do not use benzene, thinners, cleanser, or wax, nor scrub the washer with a brush. Painted surfaces or plastic parts will be damaged.
OVERFLOW FILTER
Pull the upper side of the overflow filter with two fingers into the hole ‘A’
in the direction of arrow as shown in the figure.
CLEANING THE COVER WINDOW SPIN
1.Rotate the cover window spin clockwise and pull out.
2.Cleaning the cover window spin.
3.Insert the cover window spin back and rotate it counterclockwise until locks in positon.
Remark : Should be cleaned the cover window spin at least 1 time a month.
3
8/9/2006 4:14:12 PM |