Storing stations in preset memories
There are 5 memory presets for each waveband.
1. Press the Power button to turn on the radio.
2. Tune to the required station using one of the methods previously
described .
3. Press and hold down the required preset for until the radio
beeps (greater than 2 seconds). The preset number will appear
in the display and the station will be stored under the chosen
preset button.
4. Repeat this procedure for the remaining presets.
5. Stations stored in preset memories may be overwritten by
following above procedure.
Recalling stations from preset memories
1. Press the Power button to turn on the radio.
2. Select the required waveband by repeatedly pressing the band
button.
3. Momentarily press the required Preset button, the preset
number and station frequency will appear in the display.
Setting the radio alarm
When the radio alarm is selected, the radio will turn on and play
the last station listened to. The radio alarm will sound for one hour
unless turned off by pressing the Power button. Press the Power
button whilst the alarm is sounding will cancel the alarm for 24
hours.
1. The radio alarm time can be set with the radio switched off.
2. Press and hold down the alarm radio button (preset no. 5) until
the hour digits and alarm symbol flash in the display
followed by a beep tone.
3. Set the required hour using the Tuning up/down buttons.
4. Press the alarm radio button, the minute digits will flash in the
display.
5. Set the required minute using the Tuning up/down buttons.
6. Press the alarm radio button, display will flash alarm lasting
time (from 1 hour to 4 hours) to be set for radio alarm. Using
Tuning up/down to select required alarm lasting hours then
press the alarm radio button again to complete alarm radio
setting.
7. To permanently cancel the alarm radio, press the alarm radio
button until symbol is removed from the display.8
GB