How To Change Disposable Dust
Bag – Style F & G (Some models only.)
1. Pull zipper down
2. Roll down coil spring
3.Pull bag throat off sleeve
4.Unfold new bag
TOP
How to Replace A Worn Belt
CAUTION: Turn off the switch and unplug the electrical cord before replacing belt. Belt pulleys can become hot during normal use. To prevent burns, avoid touching the belt pulley when servicing the drive belt.
IMPORTANT: Improper installation of the brush roll or brush roll belt could cause carpet or cleaner damage.
1.Release cam locks to remove bottom plate.
2.Pull up on belt to rotate it off the motor pulley. Lift up on brush roll and remove worn belt.
| Fan Cover |
Belt |
|
guide | Motor Pulley |
|
THROAT {
BOTTOM
5.Place bag throat on sleeve
6.Roll up coil spring
7.Place paper bag into outer bag NOTE: Be certain there are no folds at the top or bottom of the paper bag
Brush Roll Pulley
3. | Place new belt around brush roll. |
4. | Align brush roll pulley with belt guide. |
5. | Place rubber end cap covers |
| over both end caps (flat side |
8. Lift zipper Look for the EUREKAGENUINEPRODUCT symbol.
Ask for GENUINE EUREKA dust
Brush Roll
The rotating brush roll sweeps and combs the carpet nap. Keep the brush roll free from hair and threads so it will continue brushing the carpet nap. Replace worn brush strips when the bristles no longer touch a straight edge held across the bottom plate. There are two types of brush rolls, the chromed steel tubular brush roll or the anodized aluminum spiral brush roll. Follow the instructions for the type of brush roll featured on the cleaner.
CAUTION: Turn off the switch and unplug the electrical cord before replacing brush strips.
Brush Roll Belt
The brush roll belt on the upright vacuum cleaner drives the brush to agitate, sweep, and comb the carpet nap. The belt should be checked regularly to be sure it is in good condition. Replace the belt if it is stretching, cracking, or slipping. Cut away any hair or thread wound around the brush roll or the belt pulley because the buildup could cause the belt to rotate unevenly.
against end cap). Align holes |
and secure. |
6. Align end caps with slots in |
cleaner base. Push brush roll |
into base. |
7. Place lower side of belt into |
belt guide and pull to stretch |
the belt around the left side of |
motor pulley. Rotate pulley to |
secure belt into groove. |
8. Place slots of bottom plate |
over tabs of cleaner base. |
Seat and secure cam locks |
(refer to 1). |
8 | 8 | Look for the | GENUINE | symbol. |
|
|
| EUREKA PRODUCT |
|
Ask for GENUINE EUREKA replacement belts - No. 52100.
6
