Attach Lower Handle
Raise the dust cup support. Push the lower handle (largest end down) through the tube of the dust cup support and into the handle socket at the back of the cleaner. Make sure the notches on the lower handle face the rear of the cleaner (Fig. 1). Align the holes, insert a
Attach Lower Cord Hook
(680 Series Only)
Insert the power cord into the lower cord hook (A), as shown. Snap the hook into the lower handle. Pull up on the cord to tighten but leave enough slack near the base so the cord is not strained when the handle is lowered.
Toward Rear 
of Cleaner 
Fig. 1
A
TubeA
Handle
Socket
A
Attach Upper Cord Hook
Pull the spring on the electrical cord upward toward the top of the handle. Make sure slots in handle are positioned properly.
Dust Cup
LowerSupport
Handle
Assemble Upper Handle
Hold the upper handle so it curves away from the cleaner. Then push it down over the lower handle. Secure with the other
A |
|
|
|
|
|
| Upper | ||
|
|
|
| A | Handle | ||||
|
|
|
|
|
|
|
|
|
|
Lower
Handle
Handle
Socket
Secure Cord Clamp
Secure the electrical cord to the dust cup support with the cord clamp and screw (D). Place the cord clamp over the electrical cord. Screw the clamp to the tab below the left latch; start the screw by hand, then tighten.
Insert the lower half of the spring into the upper cord hook, as shown, Detail B. Snap the hook into the upper handle, directions below.
1. Place | 2. Press hook | 3. SNAP opposite |
inner tab | around | inner tab into |
into slot | handle | place |
|
|
|
|
|
|
Detail B
Cord Storage
Loop the cord around the large single hook or the two standard cord hooks (depending on model/series). Fasten the plug to the cord to prevent unwinding.
Hook Bag Top
Slip the ring at the top of the cloth bag over the bag support hook on the back of the cord hook.
4
