GENERAL INFORMATION
The cleaner is designed to pick up dirt and dust particles. Avoid picking up hard or sharp objects with the cleaner to avoid bag breakage, hose clogging, or possible motor damage.
Service Information
The instructions in this booklet serve as a guide to routine maintenance. For additional service information telephone our toll free number for the nearest Eureka Authorized Warranty Station. You should know the model, type and serial numbers when you call:
USA: 1-800-282-2886
Mexico:
Canada:
If you prefer, you can write to The Eureka Company, Service Division, 807 North Main Street, Bloomington, Illinois 61701, USA. In Canada write to The Eureka Company, 866 Langs Drive, Cambridge, Ontario N3H 2N7. Refer to The Eureka Warranty for complete
service information.
DO NOT OIL the motor at any time.The bearings are permanently lubricated and sealed.
Rating Plate
The model, type, and serial numbers are indicated on the rating plate located on the back side of the cleaner. For prompt and complete service information, always refer to these numbers when inquiring about service.
Model & Type______________________
Serial No. _________________________
MODEL | TYPE | SERIAL NO. |
VOLTS | AMPS. | HERTZ |
THE EUREKA COMPANY
BLOOMINGTON, ILLINOIS 61701
Automatic Motor Shut-Off
To protect from overheating, this vacuum cleaner is equipped with a thermostat which automatically shuts off the motor if it overheats. Should this happen:
1.Turn off the switch and unplug the cleaner because the thermostat will allow the cleaner to automatically start running again when the motor cools (approximately 30 minutes).
2.Check the hose, bag and filter regularly, as a clogged hose, full bag or dirty filter could cause the motor to overheat.
3.Call a Eureka Service Station if the cleaner will not operate after cooling for approximately 30 minutes.
5
