Step 2
Attach Upper Cord Hook
Pull the spring on the electrical cord upward toward the top of the handle. Make sure slots in handle are positioned properly, see Detail A.
Insert the lower half of the spring into the upper cord hook (B), as shown. Snap the hook into the upper handle, directions below.
1. Place inner tab | 2. Press hook | 3. SNAP opposite inner |
into slot | around handle | tab into place |
B
BAG SUPPORT HOOK
Step 3
Attach Lower Cord Hook
Insert the power cord into the lower cord hook (C), as shown. Snap the hook into the lower handle. Pull up on the cord to tighten but leave enough slack near the base so the cord is not strained when the handle is lowered. Wrap the cord around the two cord hooks. Fasten the plug to the cord to prevent unwinding.
Step 4
Install The Bag
Insert the bag adapter clip (E) on the bottom of the bag collar into the bag adapter retainer (F).
Push the bag collar up and forward so the locator lug slides into the slot indicated by the arrow. Then turn the cam latch (G) to lock the bag onto the rivet (H).
Loop the spring from the top of the bag onto the bag support located to the back of the upper cord hook (B).
F |
E |
H |
G |
7 |
