Sansui SLED2400 Using an AV Amplifier with built-in digital surround, Rear and right of the unit

Monitor Display modes MODE Resolution Refresh rate

Connections to other equipment

Using an AV Amplifier with built-in digital surround

If you are using an Amplifier with built-in digital surround sound, you can enjoy various audio systems including Dolby Digital Surround audio that sounds just like the movie.

Connect an AV amplifier with built-in Dolby Digital decoder, etc. as shown below.

Rear of the unit		Front
	Subwoofer	Speaker
		(Right)

To DIGITAL AUDIO COAXIAL OUT

Front

Speaker

(Left)

TV

Coaxial digital cable (not supplied)

To Coaxial	Center Speaker
Digital Audio Input
Surround	Surround
Speaker (Left)	Speaker
AV Amplifier with built-in digital surround decoder	(Right)

NOTE:

• When you are viewing digital broadcast, this unit will not work in conjunction with DTS audio or MPEG audio. There will be no sound output if connected to an AV amplifier with a built-in DTS decoder or MPEG decoder.

To connect the TV to a PC (Personal Computer)

BEFORE YOU CONNECT THIS TV TO YOUR PC, CHANGE THE ADJUSTMENT OF YOUR PC’S RESOLUTION AND REFRESH RATE (60 HZ).

Connect one end of a (male to male) VGA cable to the video cord of the computer and the other end to the VGA connector PC MONITOR IN on the rear of the TV. Attach the connectors firmly with the screws on the plug. In case of a Multimedia computer, connect the audio cord to the audio output of your Multimedia computer and to the AUDIO IN connector of the PC/DVI AUDIO IN jack of the TV.You can also connect the PC with HDMI cable. If you use HDMI cable, you don’t have to connect the audio cord. If you use DVI-to-HDMI cable, please connect audio cord as same way as VGA cable.

Press INPUT SELECT on the remote control to select PC mode.

Switch on the computer. The TV can operate as the computer monitor.

Rear and right of the unit

		VGA	640x480	60/ 72/ 75 Hz
		VGA	720x400	70Hz
		SVGA	800x600	56/ 60/ 72/ 75 Hz
		XGA	1024x768	60/ 70/ 75 Hz
To PC/DVI	To HDMI/DVI IN	WXGA	1280x768	60Hz
		WXGA	1280x720	60Hz
AUDIO IN To PC	HDMI cable (not supplied)	WXGA	1360x768	60Hz
MONITOR		To return to normal mode
IN	VGA cable (not supplied)
		Press INPUT SELECT again.

Audio cord (not supplied)

NOTE:

• The on-screen displays will have a different appearance in PC mode than in TV mode.

• If there is no video signal from the PC when the unit is in PC mode, “No signal” will appear on the TV-screen.

13EN