Assembly Instructions for HTB3 Speaker Stands (Requires a Phillips screwdriver)
If you have any questions regarding this or any other Sanus product, please contact us at
(800)
1)If you have carpeting, attach carpet spikes* with nuts (8,9) to the base (1). If you have wood or tile floors thread the pads (17) into the base.
2)The main tube mechanisms (parts 2, 3, 4, 6 & 7 pictured on the other side of this sheet) come
3)Choose the appropriate Speaker Mount.
For speakers with a threaded insert on the back, you will need to attach the mounting bracket (5B) to the tube with a flat head M5 screw (10). Attach the speaker to the mount- ing bracket using a pan head machine screw. Two pan head screw sizes (13,16) have been provided for common speakers. Other sizes are available at most hardware stores. For speakers with dual threaded inserts on the back, use the dual mount bracket (5C). Attach (either horizontally or vertically) dual mount bracket (5C) to mounting bracket (5B) with adjustable nut (12).
For speakers with keyhole mounting capability, you will need to attach the mounting bracket (5B) to the tube with a flat head M5 screw (10). Insert the thumb screw (11) through the narrow opening of the mounting bracket, then attach the adjustable nut (12). Do not tighten. The head of the thumb screw should fit into the keyhole opening on your speaker. Slide the speaker down on the thumbscrew and secure it to the stand by tightening the adjustable nut.
For speakers without mounting attachments, you will need to attach the rectangle plate (5A) to the tube using a flat head M5 screw (10). Remove the backing from one side of the double faced sponge (14) and place it on the rectangle plate with the holes in the plate and the sponge lined up. Peel the backing from the top of the double faced sponge. Press your speaker onto the rectangle plate, the adhesive on the double sided sponge will hold your speaker securely in place.
For speakers with a threaded insert on the bottom, you will need to attach the rectangle plate (5A) to the tube using a flat head M5 screw (10). Remove the backing from one side of the
4)Run your speaker wire through the hole near the top of the stand and out the bottom of the stand. Secure the stand at the desired height by tightening the plastic connector (4).
*NOTE: Carpet spikes are very sharp and may scratch floors or furniture. All sharp objects can be hazardous to children. This product may be used without carpet spikes. The deci- sion to use carpet spikes is yours; Sanus Systems will not be liable for damage or injury.
Sanus Systems 2221 Hwy 36 West, St. Paul, MN 55113
Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com 7.30.04