STAND ASSEMBLY ___________
NOTE: Skip these steps if you are wall mounting the TV.
1Place HDTV face down on a padded or cushioned flat surface to protect the screen and finish
2Carefully insert the stand base to the bottom of the HDTV.
3Secure the stand base with the four (4) screws supplied in the literature package.
4Position the HDTV on a firm and flat surface with adequate space for proper ventilation.
WALL MOUNTING (OPTIONAL)
Wall mounting of the HDTV must be performed by a skilled person.
If stand base disassembly is needed:
1Place HDTV face down on a padded or cushioned flat surface to protect the screen and finish
2Remove the four (4) screws securing the foot stand. CAUTION: Hold the stand firmly as you remove the last screw.
Use the screws you would use to attach the stand base to secure the HDTV to a wall mounting kit.
NOTE: Wall mounting kit is not included.
VESA standard interface: 400 x 360
Mounting screws measurements:
M6 (6mm) Diameter,
GETTING STARTED
BATTERY INSTALLATION
Install two (2) “AAA” batteries in the remote control. (Not included)
To ensure safe operation, please observe the following precautions:
•Replace both batteries at the same time. Do not use a new battery with a used battery.
•There’s a risk of explosion if a battery is replaced by an incorrect type.
•Do not expose the Remote Control unit to moisture or heat.
•Be sure to match the “+” and
•Please properly dispose of used up batteries.
ANTENNA CONNECTION FOR OFF-AIR SIGNALS OR CABLE
Hook up your antenna or your cable service to the HDTV’s ANT terminal with the use of a 75 OHM coaxial cable.
NOTE: Keep your indoor antenna at least 3 ft. away from the television set and any other electronic equipment.
ANTENNA
ANALOG / DIGITAL
ANTENNA IN
CABLE
Wall Mounting
Inserts
The tuner in this HDTV can receive:
•Digital and Analog off air signals from an antenna
•Analog or ClearQAM cable channels from a direct Cable TV connection.
Need help? www.sanyoctv.com 
