Basic Operation

Turning On the Projector

1

Complete peripheral connections (with a computer, VCR, etc.)

 

before turning on the projector.

2

Connect the projector's AC power cord into an AC outlet. The

 

POWER indicator flashes red in a moment and turns on red.

3

Press the POWER ON-OFF button on the top control or on the

 

remote control. The POWER indicator turns green, and the

 

cooling fans start to operate. The preparation display appears on

 

the screen and the count down starts. (A captured image can

 

be used as the preparation display. See “Capture” on page 38.)

4

After the count-down, the input source that was selected last

 

and the Lamp mode status icon appear on the screen.

26

The preparation display disappears after 30 seconds.

Selected Input Source and Lamp Mode

Lamp mode

(See page 40 for Lamp mode.)

Turning Off the Projector

1

Press the POWER ON-OFF button on the top control or on the

 

remote control, and a message "Power off?" appears on the

 

screen.

2

Press the POWER ON-OFF button again to turn off the

projector. The POWER indicator starts to flash red, and it continues while the cooling fans are operating (for about 90 seconds).

3 When the projector has cooled down enough to be turned on again, the POWER indicator lights red. Then you can disconnect the AC power cord.

TO MAINTAIN THE LIFE OF LAMP, ONCE YOU TURN PROJECTOR ON, WAIT AT LEAST 5 MINUTES BEFORE TURNING IT OFF.

DO NOT DISCONNECT AC POWER CORD WHILE COOLING FANS ARE RUNNING OR BEFORE POWER INDICATOR LIGHTS RED. OTHERWISE IT WILL RESULT IN SHORTENING LAMP LIFE.

The message disappears after 4 seconds.

NOTE

The projector cannot be turned on during the cooling period with the POWER indicator flashing red. You can turn it on again after the POWER indicator lights red.

When the On start function is on, this projector is turned on automatically by connecting the AC power cord to an AC outlet. (See page 39 for the On start function.)

Do not use the projector for more than 24 hours continuously. Turn off the projector at least once in 24 hours and give it a rest. Continuous use may result in shortening the lamp lifetime.

This projector monitors internal temperature and automatically controls the running speed of the cooling fans.

If the WARNING indicator flashes or lights red, see “Warning Indicator” on page 41.

19