8
volume of the speakerphone by using the VOLUME + and - buttons.
END CALL Function
This function allows you to end your current call and begin a new one. Pressing the
END CALL button will disconnect the current call and provide a new dial tone so you
may dial a new call.
MUTE Function
Pressing the MUTE button turns off the telephones microphone so that the other
party cannot hear you, but you can hear them. Pressing the MUTE button again
restores connection to the microphone so the other party can again hear you. The
LCD will display “MUTE” while the function is active.
FLASH Button
If you subscribe to “Call Waiting” (a special telephone service) the FLASH button is
used to connect the line to another incoming call or to establish a dial tone to make
another call while still connected to the initial caller.
Note: If you do not subscribe to Call Waiting, pressing the FLASH button during a call
will disconnect the current call.
PAUSE Function
Use this function when a delay is needed in an automatic dialing sequence. For
example, when you must dial a 9 to get an outside line or when you enter codes to
access your long distance company. A pause may also be stored in AUTO DIAL and
other memory dial entries.
Phone Book Function
You can store 70 numbers and names in the phone book, refer to the “FUNCTION
OPERATIONS”, under the “PHONEBOOK” section for details.
HEADSET Function
To use a headset, connect a headset with a 2.5mm connector into the headset jack.
To make a call, press the HEADSET button. A dial tone will be heard on the headset
and the phone may be dialed. To end the call, push the HEADSET button again.
Volume Function
The volume level of the handset, headset and speakerphone can be set using the
volume + and - buttons. To adjust, go off-hook with either the handset, headset or
speakerphone. The LCD will display the volume setting information as it is adjusted.
Ringer Volume Switch
Set the ringer volume switch to the desired position (HI/LOW/OFF). To have the maximum
ringer volume, move the ringer volume switch to the HI position. To have a low ringer
volume, move the ringer volume switch to the LOW position. If you would prefer the ringer
not to disturb you, move the ringer volume switch to the OFF position.
Pulse/Tone Switch
Set it to TONE if you have “touch tone dialing”, or set it to PULSE if you have a
“rotary dial phone”.
Buttons Function
Use these buttons to scroll through menu functions, Caller ID, Dialed Calls and Phonebook
records.
Functions