Scag Power Equipment GC-STC manual front of the machine as shown. See Figure

10.Install the new belt covers and secure. See items number 1 and number 21 on page 8 of the Blower Mounting Components section in the Illustrated Parts List for proper installation.

11.Install the hopper mounting brackets to the outside of the frame on the rear of the machine. See Figure 3-4.

Hopper

Mounting

Brackets

Rear Frame

Figure 4 A GC-STT Install Art

front of the machine as shown. See Figure 3-6.

16.Install one 7/16-14 x 1-3/4" hex head bolt into each of the four mounting holes in the weight support bar, and through the matching holes in the caster support weldment. Secure this assembly to the front of the machine using the 7/16- .5" x 1-1/4" x .083" flatwashers, and the 7/16-14 elastic stop nuts. Torque hardware to 59 ft. lbs. See Figure 3-6.

FIGURE 3-4

12.Attach the hood assembly to the machine by installing the mounting post into the hopper mounting brackets. Secure with the ring pins and tighten the locking bolts. See Figure 3-5.

FIGURE 3-6

17. Operate and test.

Locking

Bolts

Ring Pins

Locking

Bolts

Ring Pins

FIGURE 3-5

13.Install the hose from the blower assembly adapter to the hopper hood and secure using the 6-1/2" clamps.

14.Install the bag assemblies.

15.Using the weight support bar as a guide, identify the four corresponding mounting holes, and the existing hardware that will need to be removed in order to secure the weight support bar to the

4