C.4" Position - baffle is installed using the bottom set of holes on the front baffle welded inside the cutter deck. (See Figure 8). Placing the baffle in the 4" setting will enhance fall cutting (leaf pickup) and reduce cutter deck "blowout".
To Adjust the Custom-Cut Baffle height:
1.Remove the hardware securing the
Hardware location used in the illustrations are for reference only. Location of hardware may vary depending on the cutter deck size.
MOUNTING | MOUNTING | |
HARDWARE | ||
HARDWARE | ||
|
2004 CCB
Figure 5. Custom-Cut Baffle
2.Move the
3.Reinstall the mounting hardware as shown. (See Figures 6 though 8). Torque hardware to 39ft.lbs.
TOP SET OF HOLES | CARRIAGE BOLT | |
FOR 3" SETTING | ||
|
2004 CCB - 3" Setting
ELASTIC STOP
NUT
Figure 6. 3" Custom-Cut Baffle Position
MIDDLE SET OF HOLES | CARRIAGE BOLT | |
FOR | ||
|
2004 CCB -
ELASTIC STOP
NUT
Figure 7. 3-1/2" Custom-Cut Baffle Position
BOTTOM SET OF HOLES | CARRIAGE BOLT | |
FOR 4" SETTING | ||
|
2004 CCB - 4" Setting
ELASTIC STOP
NUT
Figure 8. 4" Custom-Cut Baffle Position
NEUTRAL ADJUSTMENT
Neutral has been set by your Scag dealer at the time of setup and normally does not need to be adjusted. If, however, you find that neutral has come out of adjustment, follow the procedure below.
1.Raise the drive wheels off the ground and block the caster wheels to prevent the machine from moving.
2.Make sure the speed control lever is in neutral, the steering control levers are in the neutral latch position, and the parking brake is on. Start the engine.
3.Release the parking brake and note if the tires are rotating.
11
