Schumacher 94026875, 00-99-000656 owner manual Important safety instructions, Handling warning

Schumacher Electric Corporation Model: IPD-1000

OWNER’S MANUAL

INSTANT POWER™ Jump Starter & DC Power Source

THIS PRODUCT HAS A SEALED LEAD-ACID BATTERY INSIDE THAT SHOULD BE KEPT AT FULL CHARGE FOR LONGER LIFE. RECHARGE WHEN FIRST RECEIVED (EVEN IF GREEN CHARGED LED GLOWS), AFTER EACH USE AND EVERY 3 MONTHS.

IMPORTANT SAFETY INSTRUCTIONS

Save these instructions

important safety instructions

Someone should be within range of your voice or close enough to come to your aid when you are working near a lead-acid battery.

Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing, or eyes. If acid enters the eye area, rinse with cold water for at least 10 minutes and get medical help immediately.

Do not smoke, or use matches or cigarette lighter, or allow any spark or flame near the battery or engine.

Never operate the power source unit if it has damaged lead wire or clamps. Have the lead wire replaced by a qualified technician.

Do not permit internal battery to freeze. Never charge a frozen battery.

handling warning

WARNING: Handling the cord on this product or cords associated with accessories sold with this product, may expose you to lead, a chemical known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after

handling.

Operating Instructions

Warning: Failure to follow instructions may cause damage or an explosion. Read entire instruction manual before use.

1.Turn ignition off before making cable connections.

2.Keep clear of fan blades, belts, pulleys and other parts that may cause injury.

3.Never allow clamps to touch together or to contact the same piece of metal to prevent sparking.

4.Use in a well-ventilated area.

5.Clamp the red clamp (+) to the positive terminal of the battery. (For a negative grounded system.)

6.Clamp the black clamp (-) to an unpainted and unmoving part of the chassis or engine block.

7.You can now crank the engine. If the engine does not start within 5-8 seconds, stop and wait at least 1 minute before attempting to start vehicle again.

8.After the engine starts, first disconnect the black clamp and then the red clamp in that order. Store the clamps on the ears located on the back of the case.

9.Recharge the product as soon as possible after use.

LED INDICATORS

There are 4 LED internal battery status indicator lights. Press the BATTERY STATUS button on the front of the IPD-1000 to determine the internal battery power.

Note: Numbers 1–3 below indicate charge level when not connected to AC power source or placed in docking station cradle.

1.The green CHARGED LED indicates the internal battery is fully charged.

2.The yellow RECHARGE LED indicates a 50 to 75% charge. The IPD-1000 may be used but should be recharged as soon as possible.

3.The red RECHARGE LED indicates a 50% or less charge; immediately recharge the IPD-1000.

4.The red CHARGING LED indicates the IPD-1000 is charging (connected to AC power source or placed in docking station cradle). At full charge, the green CHARGED LED will light.

CHARGING of internal battery

After removing the IPD-1000 from the carton, charge it overnight before using even if the green CHARGED LED glows.

1.To charge, plug wall charger adaptor into the CHARGING ADAPTOR PORT on the front of the device or in the IPD-1000 docking station cradle.

2.Plug the wall charger into a 120V AC electrical wall outlet. The red CHARGING LED will glow indicating there is power to the docking station cradle or unit.

3.The CHARGED LED will glow green when the battery has reached full charge. This could take up to 24 hours on some charges due to age and condition of the battery. The charger will automatically drop into a float mode and maintain the battery at full charge without damaging battery.

WARNING: Keep moisture, flammable materials and metal away for the cradle/tray. The metal contacts are electrically live and may spark when in use.

CHARGING

ADAPTOR PORT

MULTI-PURPOSE POWER SUPPLY

The IPD-1000 is a power source for all 12 volt DC accessories equipped with a 12 volt accessory plug. Make sure the device to be powered is OFF before inserting 12 volt accessory plug into 12 volt accessory outlet located on right side. The DC socket has a 15 amp automatic overload protection circuit breaker. The breaker will automatically reset after an overload occurs.

00-99-000656/0506