Schumacher MMF-120A owner manual Save Important Safety Instructions, Operating Instructions

Owner's Manual

Jump Starter

and DC Power

Source

MODEL BATTERY

MMF-120A 12 Ampere-Hour

–Save–

Important Safety Instructions

This product has a sealed lead-acid battery inside that should be kept at full charge for longer life. Recharge when first received (even if green ‘full power’ light glows), after each use and every 3 months. Failure to do this may cause battery life to be greatly reduced.

OPERATING INSTRUCTIONS

WARNING: FAILURE TO FOLLOW INSTRUCTIONS MAY CAUSE DAMAGE OR AN EXPLOSION. READ ENTIRE INSTRUCTION MANUAL BEFORE USE.

1.Turn ignition off before making cable connections.

2.Use in a well-ventilated area.

3.Clamp the red clamp to the positive terminal of the battery. (For a negative grounded system.)

4.Clamp the black clamp to an unpainted and unmoving part of the chassis or engine block.

5.Keep clear of fan blades, belts, pulleys and other parts that may cause injury.

6.You can now crank the engine. If the engine does not start, wait at least 3 minutes before attempting to start vehicle again. (This permits the battery to cool down.)

7.After the engine starts, first disconnect the black clamp and then the red clamp in that order. Store the clamps on the ears located on the sides of the case.

8.Recharge the MityMite as soon as possible after use.

9.Never allow clamps to touch together or to contact the same piece of metal to prevent sparking.

LED INDICATORS

To check the internal battery’s status, press the red button on the front of MityMite.

The led lights will indicate as follows:

1.A red light indicates a 50% or less charge and you should immediately recharge MityMIte.

2.A yellow light indicates a 50 to 75% charge. MityMite may be used but should be recharged as soon as possible.

3.A green light indicates the internal battery is fully charged.

CHARGING OF INTERNAL BATTERY WITH BUILT-IN CHARGER.

After removing the MMF-120A from the carton, charge it over- night before using even if the green Full Power light glows.

1.To charge, plug extension cord into charger plug on the side of the MityMite.

2.Plug the extension cord into 120V AC source. (Electrical outlet.)

3.The red light will glow while charging.

4.The green light will glow when the battery has reached full charge. The charger will automatically drop into a float mode and maintain the battery at full charge.

MULTI-PURPOSE POWER SUPPLY

The MMF-120A is a power source for 12 volt DC accessories that are equipped with a cigarette lighter adapter plug. The DC socket has a 15 amp automatic overload protection circuit breaker. Reset the breaker by pushing the breaker button lo- cated on the back of MityMite.

Do not permit the battery in the MMF-120A to freeze. Never attempt to recharge a frozen battery.

SCHUMACHER ELECTRIC CORPORATION

801 BUSINESS CENTER DRIVE • MOUNT PROSPECT, ILLINOIS 60056-2179

Send Warranty Product Repairs to: 1025 E. Thompson, Hoopeston, IL 60942-0280

Call Customer Service if you have questions: 1-800-621-5485

00-99-000271/0403

1