MAINTENANCE/CLEANING INSTRUCTIONS

Very little maintenance is required for the battery charger. Follow common sense in wiping the charger clean and store in a clean, dry area.

1.After use, wipe all battery corrosion and other dirt or oil from clip, cord, and the charger case. Use a dry cloth.

2.Coil charger cords to prevent damage.

3.Have any cracked or frayed cords replaced by a qualified professional.

4.Store battery charger in a clean, dry area.

TROUBLESHOOTING

If a problem does occur, check the following:

PROBLEM

POSSIBLE

SOLUTION

 

 

 

No meter reading.

Charger is not plugged in

Plug in

 

Connections are reversed

With charger unplugged, reverse clips and

 

 

reconnect (rock back and forth to bite in)

 

Poor electrical connection

Clean clips and battery poles and reconnect (roll

 

 

back and forth to bite in)

 

AC outlet is dead

Plug in a lamp or other appliance to check for

 

 

voltage

 

Battery is defective (will not accept

Have battery checked.

 

charge)

 

 

 

 

Charger will not taper down.

Battery has problem and will not take

Have battery checked.

 

full charge.

 

 

 

 

High meter reading

Battery is defective (will not take a

Have battery checked.

 

charge).

 

 

 

 

Charging current is less than full

Battery is partially charged.

Continue charging.

output rating of charger.

 

 

 

Battery is defective (battery plates are

Have checked and replace battery.

 

crusted) and will not accept a full

 

 

charge.

 

 

AC power supply is low.

Plug charger into another grounded AC outlet.

 

 

 

Ammeter needle moves to extreme

Severely discharged battery (but

Allow charging to continue until battery has

right, remains a short time, then

otherwise good battery)

recovered sufficiently to take a charge (Circuit

returns to zero, accompanied by a

 

breaker will continue to cycle and needle will

clicking sound.

 

swing side to side until battery has recovered).

 

Battery is defective (will not accept

Have battery checked.

 

charge)

 

 

Charger is cycling after circuit breaking

Wait until charger automatically resets itself

 

overload.

(DO NOT RETURN FOR SERVICE).

 

 

 

LIMITED WARRANTY

SCHUMACHER ELECTRIC CORPORATION, 801 BUSINESS CENTER DRIVE, MT. PROS-

THIS IS THE ONLY EXPRESS LIMITED WARRANTY AND THE MANUFACTURER NEI-

PECT, ILLINOIS 60056-2179 MAKES THIS LIMITED WARRANTY TO THE ORIGINAL PURCHASER

THER ASSUMES NOR AUTHORIZES ANYONE TO ASSUME OR MAKE ANY OTHER OBLIGA-

AT RETAIL OF THIS PRODUCT. THIS LIMITED WARRANTY IS NOT TRANSFERABLE.

TION TOWARDS THE PRODUCT OTHER THAN THIS EXPRESS LIMITED WARRANTY. THE

Schumacher Electric Corporation warrants this battery charger for two years from date of purchase

MANUFACTURER MAKES NO WARRANTY OF MERCHANTABILITY OR FITNESS FOR PUR-

at retail against defective material or workmanship. If such should occur, the unit will be repaired or

POSE OF THIS PRODUCT AND EXPRESSLY EXCLUDES SUCH FROM THIS LIMITED WAR-

replaced at the option of the manufacturer. It is the obligation of the purchaser to forward the unit together

RANTY.

with proof of purchase, transportation and/or mailing charges prepaid to the manufacturer or its autho-

SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL

rized representative.

OR CONSEQUENTIAL DAMAGES OR LENGTH OF IMPLIED WARRANTY SO THE ABOVE

This limited warranty is void if the product is misused, subjected to careless handling, or repaired

LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU.

by anyone other than the manufacturer or its authorized representative.

THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO

The manufacturer makes no warranty other than this limited warranty and expressly excludes any

HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.

implied warranty including any warranty for consequential damages.

 

6

Page 6
Image 6
Schumacher SE-3002 MAINTENANCE/CLEANING Instructions, Troubleshooting, Problem Possible Solution, Limited Warranty