INT N
our unit can be connected to a wireless network (Wi-Fi) or an Ethernet. This
ote: Before operating this mode, make sure that you have read and understood
in “PREREQUISITES FOR INTERNET RADIO” and
Wi
1. cable (not supplied). Refer to “CONNECTIONS”
2.
epending on your Internet connection type, select “DHCP” or “STATIC IP” to
the Internet. In “DHCP” mode, an IP address is
n the correct IP data as follows:
P address” Æ “IP mask” Æ “IP gateway” Æ “DNS”
cess point (Wi-Fi) to the
2. Select “Settings” d display
TATIC IP”.
ter entering the WEP or WPA key, you need to select “DHCP” or
t the number/
ERNET RADIO OPERATIO
Y
allows you to enjoy the vTuner live Internet radio service.
Nthe instructions
“CONNECTIONS”.
Configurations setup red connection (Ethernet)
Connect the unit to the broadband Internet using an RJ45
Ethernet
for more details.
Select “Settings” Æ “System” Æ “Connection” Æ “Ethernet”
Æ “DHCP” or “STATIC IP”.
D
enable the unit to connect to
automatically assigned to the unit. In “STATIC IP” mode, you must check with
your service provider to obtai
“I
Wi-Fi connection
. Use a router (not supplied) to connect the wireless ac1broadband Internet, refering to the “CONNECTIONS”
section.
Æ “System” Æ “Connection” Æ “Wi-Fi”. The
unit will scan for all available wireless networks an
the network names (SSID).
3. Select the network and press the SELECT button to confirm.
. Select the correct encryption security system: Open network, 4WEP key or WPA.
rk: Select “DHCP” or “S5. Open netwo
WEP key: Enter the WEP code.
WPA key: Enter the WPA code.
ote: AfN “STATIC IP”.
Turn the SCROLL/SELECT/SNOOZE knob to adjus
character and press it to confirm. Then use the P2/ P4/ and button to
hold down the move to the previous or next number/ character. Press and
SCROLL/SELECT/SNOOZE knob (or press the
butto
control) to complete an n on the remote
d confirm the entry.
r both the wired (Ethernet) and Wi-Fi connection, the message “Connection
successful” will be displayed to confirm that the internet is connected. If this is not
the case, “Connection failed” will be displayed. You should try above steps again
to enter correct IP data, WEP or WPA key and also make sure that the wired or
wireless networks are available and working.
Fo
GB-
10