Drive mounting, Mounting dimensions | Seagate ST3000NC000 guide

www.seagate.com

3.4Drive mounting

You can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the bottom- mounting holes. Refer to Figure 7 for drive mounting dimensions. Follow these important mounting precautions when mounting the drive:

•Allow a minimum clearance of 0.030 inches (0.76mm) around the entire perimeter of the drive for cooling.

•Use only 6-32 UNC mounting screws.

•The screws should be inserted no more than 0.150 inch (3.81mm) into the bottom or side mounting holes.

•Do not overtighten the mounting screws (maximum torque: 6 inch-lb).

Weight: (maximum)	3TB models	2TB models	1TB models

	626g (1.38 lb)	535g (1.18 lb)	400g (0.88 lb)

	Note	These dimensions conform to the Small Form Factor Standard documented
	Note	in SFF-8301 and SFF-8323 found at www.sffcommittee.org
		in SFF-8301 and SFF-8323 found at www.sffcommittee.org

	Figure 7 Mounting dimensions
	1TB model height

in mm

Breather

Hole

in

mm

2 & 3TB model height

in mm

Constellation CS Serial ATA Product Manual, Rev. C

24

Image 29

Seagate ST3000NC000, ST1000NC001, ST1000NC000, ST2000NC001, ST2000NC000, ST3000NC002 manual Drive mounting, Mounting dimensions

Contents

ConstellationCS Serial ATA Revision Date Description of Change Document Revision History Contents Sata Interface Figures Seagate Technology Support Services Introduction About the Sata interface Specification summary tables Drive Specifications Formatted capacity Model Formatted capacity Guaranteed sectors Bytes per sector Default logical geometry LBA modePhysical characteristics LBA mode Power consumption Power specificationsSeek time Start/stop times Peak operating current sequential write 3TB Drive DC power requirements Typical current profiles 3TB model current profile 2TB model current profile 1TB model current profile Voltage tolerance Conducted noise Power modes Heads Spindle Buffer Power-management modes PowerChoice is invoked using one of two methods Extended Power Conditions PowerChoiceTMPower Condition Name Power Condition ID Description EPC Subcommands Descriptions Power Condition Name Manufacturer Default Timer ValuesPowerChoice Supported Extended Power Condition Indentifiers Power Condition Power Condition Name Identifiers Environmental limits Ambient temperatureHumidity Operating Shock AltitudeVibration Non-operating Electromagnetic immunity AcousticsTest for Prominent Discrete Tones PDTs Electromagnetic compatibility Agency certification Safety certification Australian C-Tick N176 FCC verificationKorean RRL Environmental protection Product warrantyChina Restriction of Hazardous Substances RoHS Directive Corrosive environment Product repair and return information ShippingStorage Sata cables and connectors Handling and static-discharge precautionsConfiguring the drive Drive mounting Mounting dimensions ATA Security Erase Unit Command on SED Sata drives Power requirementsSanitize Feature Set on SED Drives Data encryption Hot-Plug compatibility Sata Interface Sata connector pin definitions Sata device plug connector pin definitions Command name Command code in hex Supported ATA commands F1H Word Description Value Identify Device command 69-74 Bit Word Smart error login is supported 0CH Set Features command Code in features register A.R.T. command 3 S.M.A.R.T. commands Constellation CS Serial ATA Product Manual, Rev. C Index Constellation CS Serial ATA Product Manual, Rev. C Constellation CS Serial ATA Product Manual, Rev. C Americas Seagate Technology LLC